Quick-Connect Terminal Sizes Explained
3/16″ and 1/4″ tabs, PCB pins, screw terminals and wire leads — how to measure and specify them.
What is a quick-connect terminal?
A quick-connect, or spade, terminal is a flat metal tab on the switch that mates with a push-on receptacle on the wiring harness. It allows fast assembly and service without soldering. Micro switches commonly use 3/16″ (4.8 mm) or 1/4″ (6.3 mm) tabs, with 2.8 mm (0.110″) tabs on very small models.
Common terminal sizes
| 2.8 mm (0.110″) | Compact switches and low-current control circuits |
|---|---|
| 4.8 mm (3/16″) | Most appliance micro switches; common in North America |
| 6.3 mm (1/4″) | Higher-current switches, power switches and appliance mains connections |
| PCB pins | Direct mounting on control boards |
| Screw terminals | Field wiring and larger conductors |
| Wire leads | Pre-assembled harnesses and sealed assemblies |
How to measure a quick-connect tab
Measure the width of the flat tab with calipers, not the receptacle. The tab thickness also matters: common thicknesses are 0.5 mm and 0.8 mm, and a receptacle designed for one may fit the other loosely or too tightly. When in doubt, match the original switch and harness exactly.
Male and female parts
The switch usually has the male tab, and the harness has the female receptacle. Receptacles are available with and without insulation; insulated types reduce the risk of accidental contact but must be rated for the application temperature.
Crimping and assembly
- Use the crimp tool specified for the terminal and wire gauge.
- Pull-test each connection after crimping.
- Route wires so they do not put strain on the switch tab.
- Keep terminals clean and free of solder, adhesive or conformal coating.
Common mistakes
- Forcing a 1/4″ receptacle onto a 3/16″ tab, which spreads the receptacle and causes intermittent contact.
- Using an uninsulated receptacle where the terminal is accessible to the user.
- Mixing tab thicknesses and getting a loose fit that heats under load.
- Bending the switch tab to align the harness — the tab can crack and overheat.
Specifying terminals on a Toneluck switch
Tell us the tab width, thickness and orientation, and whether you need PCB pins, screw terminals or pre-assembled leads. For OEM projects, lead length, connector type and sealing can be customised. Browse the micro switch range for available terminal options.
Keep reading
How to Choose a Micro Switch for Appliances
Electrical load, contact form, actuator, terminals, environment and approvals — the full selection checklist.
Read the guideMicro Switch Replacement Guide for US Appliances
How to identify, match and safely replace a micro switch in common US appliances.
Read the guide125VAC vs 250VAC Micro Switches
What the voltage rating means, when a 250VAC switch can be used at 125VAC, and how to derate for inductive loads.
Read the guideNeed a switch that fits your design?
Send us your drawings, ratings and volume. We will recommend the closest platform and quote a custom sample.