NC vs NO vs SPDT: What Your Appliance Needs
Normally open, normally closed and changeover contacts explained, with appliance examples and safety notes.
The three basic contact arrangements
A micro switch can be wired in several ways. The three most common are:
- Normally open (NO) — the circuit is open in the rest position and closes when the actuator is pressed.
- Normally closed (NC) — the circuit is closed in the rest position and opens when the actuator is pressed.
- Single pole double throw (SPDT) — one common terminal connects to either of two outputs, depending on the actuator position.
“Normally” refers to the un-actuated state, not to whether the appliance is switched on.
Typical appliance uses
| NO | Start buttons, door-present detection, cycle enable when a latch closes |
|---|---|
| NC | Safety interlocks, monitor switches, stop circuits, door-open detection |
| SPDT | Changeover between two circuits, direction or mode selection, status feedback |
Safety implications
In a safety circuit, the contact form determines how the appliance behaves if the switch or its wiring fails. A door interlock that must stop the appliance when the door opens is often wired NC so that a broken wire or detached connector also stops operation. Always match the original circuit design and test the safety function after replacement.
Microwave monitor circuits are a specific example: the monitor switch is normally closed and is designed to blow the fuse if the interlocks fail. Substituting a different contact form can defeat that protection.
How to identify the contact form
Look for markings on the switch: NO, NC and C (common) are often moulded into the body. A multimeter set to continuity will show which terminals are connected in the rest position and which connect when the actuator is pressed.
Replacement rules
- Never substitute NO for NC (or vice versa) without checking the control logic.
- When replacing an SPDT switch, confirm which output is used and whether the unused terminal is isolated.
- Check the number of terminals — a 3-terminal switch may be SPDT or a combined NO/NC design.
- Test the appliance through a complete cycle and verify all safety functions.
Choosing for a new design
Start from the failure mode you need: should the load be on or off when the actuator is at rest, and what should happen if the switch fails? Then select the contact form, actuator and rating. Toneluck supplies SPST, SPDT and DPDT micro switches; the furnace door safety guide shows how contact form is chosen for a safety interlock.
Keep reading
How to Choose a Micro Switch for Appliances
Electrical load, contact form, actuator, terminals, environment and approvals — the full selection checklist.
Read the guideMicro Switch Replacement Guide for US Appliances
How to identify, match and safely replace a micro switch in common US appliances.
Read the guide125VAC vs 250VAC Micro Switches
What the voltage rating means, when a 250VAC switch can be used at 125VAC, and how to derate for inductive loads.
Read the guideNeed a switch that fits your design?
Send us your drawings, ratings and volume. We will recommend the closest platform and quote a custom sample.